Bravos Won’t Spin or Drain
Top-load Bravos uses a fragile actuator that fails first. Wet clothes, no spin, sometimes a clicking sound. We replace the actuator and gear case.
Your Maytag Bravos won’t spin, the Centennial top-load is stuck, or the Maxima front-load door is locked. BJE Appliance Repair sends a trusted Maytag tech the same day with OEM Maytag parts and a 90-day warranty — built tough, fixed tough.
Maytag is built tough — but every appliance has wear points. We know the Maytag-specific failures cold.
Top-load Bravos uses a fragile actuator that fails first. Wet clothes, no spin, sometimes a clicking sound. We replace the actuator and gear case.
Centennial top-loaders flag a lid-lock fault if the lid switch warps. We replace the switch and align the strike.
End-of-cycle door stays locked. Failed door lock actuator or stuck logic. We retrieve clothes, replace the lock, and verify with a full cycle.
Old Neptune front-loaders develop a tub bearing roar in spin. We replace the spider, bearings, and seal as a kit.
Drum spins, no heat. Cause is a thermal fuse, cycling thermostat, or heating element. We test in sequence and replace the failed part.
Maytag French-door ice makers ice up. We thaw, install the updated tray, and check the inlet valve.
Continuous spark even after the burner lights. Failed spark module or wet igniter switch. We dry, test, and replace.
End of cycle, water in the bottom. Clogged drain hose, stuck check valve, or failed drain pump. We pull the pump, clear the line, and test.
Maytag is famous for commercial-grade laundry and 10-year direct-drive motors. Our trucks carry the Maytag-specific actuators and bearing kits that fail most often.
Click any tile below to jump to the matching Atlanta service page with Maytag-specific common faults and pricing.
Cooling failures, ice maker faults, water dispenser drips, control board errors.
Maytag refrigerator overhaul →Drain pump, door boot, control module, drum bearings, suspension rods.
Maytag washer overhaul →Heating element, thermal fuse, drum rollers, vent restriction, lint clogs.
Maytag dryer overhaul →Wash motor, drain pump, door latch, spray arm jets, electronic display board.
Maytag dishwasher overhaul →Bake element, igniter, sensor probe, control board, door hinges and gaskets.
Maytag oven overhaul →Surface element, induction coil, infinite switch, glass top, spark module.
Maytag cooktop overhaul →Blower motor, capacitor, halogen lamps, charcoal filter, touch panel.
Maytag range hood overhaul →Magnetron, diode, door switch, turntable motor, control panel and key matrix.
Maytag microwave overhaul →Maytag parts share the Whirlpool catalog — broad availability and predictable cost. The $89 diagnostic fee is credited toward the repair.
On-site diagnosis, model lookup, and a written flat-rate quote. Fee is credited toward the repair.
Door switch, thermistor, fan motor, igniter, water valve, control knob, harness fix.
Control board reflash, drain pump, evaporator fan, motor coupling, dispenser overhaul.
Compressor, sealed system, drum bearings, magnetron, induction generator, oven element pack.
Maytag Commercial Technology motors carry a 10-year warranty. We help file the warranty claim if your unit qualifies.
No surprise charges. No fishing for problems. Just a quick, factory-style Maytag diagnostic and a written flat-rate price before any tools come out.
Tell us your Maytag model number and what the appliance is doing. We pre-stage the most likely OEM parts before the truck rolls.
A factory-trained tech reads error codes, runs a forced-cycle test, and inspects every Maytag-specific failure point on a printed checklist.
We hand you a written, all-inclusive price — parts plus labor. Nothing starts until you sign.
The fix is performed on-site, tested through a full cycle, and backed by a 90-day parts and labor warranty.
Real reviews from Maytag households metro-wide. We never edit feedback.
Our Maytag Bravos stopped spinning right when we had house guests. The tech showed up the same day, replaced the actuator, and gave the gear case a check-up. Honest pricing, fast service.
We have an old Neptune from the early 2000s that finally roared in spin. They replaced the bearings, spider, and seal as a kit and now it’s back to silent. Saved us from buying new.
My Maxima front-loader was stuck shut after a power flicker. The tech showed me the manual unlock, retrieved the wet clothes, and replaced the door lock in 30 minutes. Even cleaned the door boot.
The Maytag dryer wouldn’t heat. Tech found a tripped thermal fuse from a vent blockage. Cleaned the run, replaced the fuse, and now drying time is 35 minutes instead of two hours.
Maytag is the brand of choice in many Atlanta laundry rooms thanks to the 10-year motor warranty. Our crew dispatches from Decatur to every neighborhood below.
The honest answers we give Atlanta Maytag owners on the phone every day.
Yes — if your unit was registered. The Maytag Commercial Technology direct-drive motor is covered for 10 years from purchase. We help you check the registration and file the claim if it applies.
Almost certainly a failed actuator. The actuator engages the spin gear. When it fails, the motor turns but the basket doesn’t. Replacement is fast and inexpensive.
It depends on age and condition. If the tub bearings are still good, replacing the door boot and seal is worth it. If the bearings are roaring too, we quote the full kit and you decide.
Many parts are interchangeable. Both are owned by Whirlpool Corporation and share a parts catalog for items like drain pumps, door locks, and timers. Bearing kits and outer cabinets are model-specific.
Step one is verifying power at the junction box. If power is good, we test the door latch switch, the thermal fuse on the control board, and the board itself.
Most Maytag repairs are 45 to 75 minutes on the same visit. Tub bearing jobs need 2-3 hours and may continue into a follow-up visit if special tools are required.
Yes. We service Maytag Commercial Technology coin-op and on-premises units in apartment complexes, gyms, and pet groomers across metro Atlanta.
Yes. The most common cause is the ice maker tray harness. We test the harness, the inlet valve, and the optical sensor (on newer models). Most ice-maker repairs are completed same visit.
If you have a mix of brands or a non-Maytag in trouble, every other major brand we service is one click away.
Atlanta’s rugged Maytag service — honest pricing, OEM parts, and 90 days of warranty on every fix.
(678) 647-9315