No Ice at All
Bin is empty for days. Most common cause: clogged water inlet valve from Atlanta’s hard water, or a failed ice maker module that controls the cycle.
Your ice maker stopped producing, the bin is empty, or the cubes are cloudy and slow. BJE Appliance Repair sends a certified ice machine technician the same day — for built-in undercounter units, refrigerator ice makers, and standalone home machines.
Pinpoint the symptom and we’ll match it to the failed component. Every issue below is covered by our same-day diagnostic and flat-rate quote.
Bin is empty for days. Most common cause: clogged water inlet valve from Atlanta’s hard water, or a failed ice maker module that controls the cycle.
Maker runs but only fills the bin every two days. Worn compressor, scaled-up evaporator plate, or a slow-leaking water valve.
Puddle around or under the unit. Cracked water line, failed inlet valve gasket, or a clogged drain pump on undercounter units.
Cloudy cubes or off-flavor. Atlanta’s hard water leaves mineral deposits on the evaporator. Time for a deep clean and a fresh water filter.
Cubes are stuck together or only half-formed. Low water pressure, a clogged inlet screen, or a worn-out thermistor calling for an early harvest.
Loud noise from the cabinet. Failed condenser fan, worn harvest motor, or a stuck eject lever in the harvest arm.
Sub-Zero, Scotsman, and U-Line ice makers throw error codes for sensor faults, water faults, and harvest failures. We decode and fix the root cause.
Bin overflows, cubes spill onto the floor. Failed bin level switch or a stuck shutoff arm. Quick fix.
Sheet of frost on the evaporator plate. Bad defrost system, a torn door gasket, or a leaking refrigerant line.
Ice tastes musty even after cleaning. Mold in the water reservoir or a contaminated water filter. We sanitize and replace.
From a $400 countertop nugget machine to a $4,000 built-in Sub-Zero clear-ice maker, we service every ice machine sold for residential use. Trucks carry inlet valves, modules, and water filters for top Atlanta brands.
Our techs carry brand-specific water valves, control modules, and condenser parts for the brands below. Sub-Zero and Scotsman certifications let us handle the hardest-to-find parts.
Most ice maker repairs in Atlanta land in one of these four buckets. Our $89 diagnostic is applied toward the repair if you proceed. No hidden fees.
On-site diagnosis, model lookup, and a written flat-rate quote. Fee is credited toward your repair.
Water filter, inlet screen cleaning, fill tube de-ice, bin level switch, water inlet valve.
Ice maker module, harvest motor, condenser fan, drain pump, thermistor, evaporator descale.
Compressor, sealed system work, Sub-Zero / Scotsman specialty parts, undercounter relocation.
Prices include parts, labor, and tax. We never bill by the hour. Your written quote is your final price.
Four straightforward steps. No upselling, no hourly billing — just ice in the bucket again.
Tell us what the ice maker is doing (no ice, leaking, cloudy cubes) and the model. We book a same-day or next-morning visit.
A certified ice technician arrives in a marked van, tests the water and electrical paths, and finds the failed part — usually within 25 minutes.
You receive a written, all-in price before any tools come out. If you choose not to proceed, you only pay the $89 diagnostic.
We install OEM parts, run two full freeze cycles, sanitize the water reservoir, clean the work area, and back it with our written warranty.
Four reviews from Atlanta-area homes whose ice makers we serviced in the past 60 days.
“Our U-Line undercounter ice maker in the basement bar stopped making ice. Tech found the water inlet valve was clogged with calcium. Quick descale, new valve, full bin by morning.”
“Sub-Zero clear-ice maker was making cloudy cubes for months. Most shops won’t touch Sub-Zero. BJE swapped the filter, descaled the plate, and the cubes are crystal clear again.”
“The Scotsman nugget machine at our pool house quit completely. Diagnosis was a failed harvest motor. Repair quote was reasonable and the unit is back in action.”
“Refrigerator ice maker module on our LG French door died after 3 years. Tech replaced the OEM part in 30 minutes. Better quality cubes than when it was new.”
Our trucks reach every part of metro Atlanta with no travel charges in our standard zone.
Common questions Atlanta homeowners ask about ice maker problems — answered honestly.
One phone call. A certified ice machine technician at your door the same day. OEM parts, a flat-rate quote, and a 90-day warranty.
(678) 647-9315