Atlanta’s Ice Machine Specialists Ice Maker Repair in Atlanta GA

Your ice maker stopped producing, the bin is empty, or the cubes are cloudy and slow. BJE Appliance Repair sends a certified ice machine technician the same day — for built-in undercounter units, refrigerator ice makers, and standalone home machines.

Same-day service OEM parts on truck All major brands 90-day warranty
Modern Atlanta kitchen with built-in ice maker under the marble counter
Every Style Built-in, undercounter, refrigerator-mounted, and standalone home ice makers serviced.
4.9 / 5 starsFrom 127 verified reviews
L&I
Licensed & InsuredBackground-checked techs
90d
90-Day WarrantyParts and labor covered
$$
Flat-Rate QuotesWritten before any work
10 Most Common Ice Maker Problems

What We Fix on Atlanta Ice Makers

Pinpoint the symptom and we’ll match it to the failed component. Every issue below is covered by our same-day diagnostic and flat-rate quote.

No Ice at All

Bin is empty for days. Most common cause: clogged water inlet valve from Atlanta’s hard water, or a failed ice maker module that controls the cycle.

Slow Ice Production

Maker runs but only fills the bin every two days. Worn compressor, scaled-up evaporator plate, or a slow-leaking water valve.

Ice Maker Leaking Water

Puddle around or under the unit. Cracked water line, failed inlet valve gasket, or a clogged drain pump on undercounter units.

Cloudy or Bad-Tasting Ice

Cloudy cubes or off-flavor. Atlanta’s hard water leaves mineral deposits on the evaporator. Time for a deep clean and a fresh water filter.

Ice Cubes Too Small

Cubes are stuck together or only half-formed. Low water pressure, a clogged inlet screen, or a worn-out thermistor calling for an early harvest.

Loud Buzzing or Grinding

Loud noise from the cabinet. Failed condenser fan, worn harvest motor, or a stuck eject lever in the harvest arm.

Display Shows Error Code

Sub-Zero, Scotsman, and U-Line ice makers throw error codes for sensor faults, water faults, and harvest failures. We decode and fix the root cause.

Ice Maker Won’t Stop Making Ice

Bin overflows, cubes spill onto the floor. Failed bin level switch or a stuck shutoff arm. Quick fix.

Frost Buildup Around Maker

Sheet of frost on the evaporator plate. Bad defrost system, a torn door gasket, or a leaking refrigerant line.

Smelly or Moldy Ice

Ice tastes musty even after cleaning. Mold in the water reservoir or a contaminated water filter. We sanitize and replace.

Every Install High-end Atlanta kitchen with undercounter ice maker beside the wine cooler
Style & Brand Coverage

Every Ice Maker Type — Repaired Right

From a $400 countertop nugget machine to a $4,000 built-in Sub-Zero clear-ice maker, we service every ice machine sold for residential use. Trucks carry inlet valves, modules, and water filters for top Atlanta brands.

  • Refrigerator-mounted ice makers — Whirlpool, GE, Samsung, LG factory ice modules with auger and harvest motor
  • Undercounter built-in ice makers — U-Line, Scotsman, Sub-Zero, Marvel cabinet-style units with drain pumps
  • Nugget & pellet ice makers — Opal, GE Profile, Scotsman Brilliance soft-chewable ice machines
  • Clear-ice gourmet makers — Sub-Zero ice maker, Scotsman Brilliance Sonic for cocktail-grade cubes
  • Commercial-grade ice machines — Hoshizaki, Manitowoc, Ice-O-Matic in Atlanta home bars and outdoor kitchens
  • Standalone portable ice makers — Frigidaire, EdgeStar, NewAir countertop units
  • Built-in clear-ice cube — KitchenAid, Wolf, Thermador integrated paneled ice modules
Factory-Trained on Every Brand

Ice Maker Brands We Service in Atlanta

Our techs carry brand-specific water valves, control modules, and condenser parts for the brands below. Sub-Zero and Scotsman certifications let us handle the hardest-to-find parts.

Atlanta’s First Call When the Ice Stops Coming

No ice in the middle of an Atlanta heat wave is a real problem. Since 2010, metro homes and home bars have called BJE to bring back the cubes — usually the same day, with the right inlet valves and modules on the truck.

1,400+Ice Makers Fixed
92%First-Visit Repairs
Same DayMost Service Calls
Honest Atlanta Pricing

Ice Maker Repair Cost in Atlanta

Most ice maker repairs in Atlanta land in one of these four buckets. Our $89 diagnostic is applied toward the repair if you proceed. No hidden fees.

Diagnostic Visit
$89

On-site diagnosis, model lookup, and a written flat-rate quote. Fee is credited toward your repair.

Light Repairs
$140–$250

Water filter, inlet screen cleaning, fill tube de-ice, bin level switch, water inlet valve.

Mid-Level Repairs
$250–$440

Ice maker module, harvest motor, condenser fan, drain pump, thermistor, evaporator descale.

Heavy Repairs
$440+

Compressor, sealed system work, Sub-Zero / Scotsman specialty parts, undercounter relocation.

Prices include parts, labor, and tax. We never bill by the hour. Your written quote is your final price.

From Empty Bin to Full Bucket

How a Same-Day Ice Maker Repair Works

Four straightforward steps. No upselling, no hourly billing — just ice in the bucket again.

1

Call & Describe

Tell us what the ice maker is doing (no ice, leaking, cloudy cubes) and the model. We book a same-day or next-morning visit.

2

Diagnose On-Site

A certified ice technician arrives in a marked van, tests the water and electrical paths, and finds the failed part — usually within 25 minutes.

3

Approve a Flat-Rate Quote

You receive a written, all-in price before any tools come out. If you choose not to proceed, you only pay the $89 diagnostic.

4

Repair & Test Cycle

We install OEM parts, run two full freeze cycles, sanitize the water reservoir, clean the work area, and back it with our written warranty.

Sleek Atlanta kitchen with stainless steel ice machine and counter setup
Real Atlanta Customers

What Ice Maker Owners Are Saying

Four reviews from Atlanta-area homes whose ice makers we serviced in the past 60 days.

★★★★★

“Our U-Line undercounter ice maker in the basement bar stopped making ice. Tech found the water inlet valve was clogged with calcium. Quick descale, new valve, full bin by morning.”

JM
Jordan M.
Tucker, GA
★★★★★

Sub-Zero clear-ice maker was making cloudy cubes for months. Most shops won’t touch Sub-Zero. BJE swapped the filter, descaled the plate, and the cubes are crystal clear again.”

BV
Beverly V.
Buckhead, Atlanta
★★★★★

“The Scotsman nugget machine at our pool house quit completely. Diagnosis was a failed harvest motor. Repair quote was reasonable and the unit is back in action.”

KH
Kenny H.
Acworth, GA
★★★★★

“Refrigerator ice maker module on our LG French door died after 3 years. Tech replaced the OEM part in 30 minutes. Better quality cubes than when it was new.”

YR
Yasmin R.
Stone Mountain, GA
Real Questions, Real Answers

Atlanta Ice Maker Repair FAQ

Common questions Atlanta homeowners ask about ice maker problems — answered honestly.

Why did my ice maker stop making ice?
The most common cause in Atlanta is a clogged water inlet valve from hard water mineral buildup. Other causes include a failed ice maker module, a frozen fill tube, or a tripped bin level switch. Our tech tests each part on-site.
How much does ice maker repair cost in Atlanta?
Most ice maker repairs in Atlanta fall between $140 and $440 all-in (parts, labor, and trip). Inlet valves and water filter swaps are at the lower end. Compressor work, Sub-Zero, and Scotsman specialty parts are higher. We give a written quote first.
Why is my ice cloudy or cubes too small?
Cloudy ice is almost always caused by mineral deposits in the water from Atlanta’s hard water supply. Replace the water filter and descale the evaporator. Small cubes usually mean low water pressure or a clogged inlet screen.
Do you fix Sub-Zero and Scotsman ice makers?
Yes. Our techs are factory-authorized on Sub-Zero, Scotsman, U-Line, and Marvel built-in ice makers. We carry condenser fans, harvest assemblies, and inlet valves for the most common Atlanta builds.
How often should I clean my ice maker?
In Atlanta, we recommend a full descale every 6 months because of hard water. Wipe down the bin and replace the water filter every 6 months as well. We offer maintenance visits along with repairs to prevent buildup.
My ice maker is leaking. Is that an easy fix?
Usually yes. Leaks are most often a cracked water supply line, a failing inlet valve gasket, or a clogged drain pump on undercounter units. We diagnose and repair leaks the same day. Don’t ignore them — ice maker leaks can damage cabinets and floors.
Is it worth repairing an old ice maker?
For built-in or undercounter ice makers, repair almost always wins — replacement runs $1,800+ plus install. For refrigerator-mounted ice makers under 7 years old, repair makes sense if the part is under $250. We give honest cost-versus-replace advice every time.
How long does an ice maker repair take?
Most ice maker repairs are completed in 45 to 90 minutes on-site. We then run two full freeze cycles to verify cube quality before leaving. You will see ice within 4 hours after we leave.

Ice Maker Down? Let’s Get the Cubes Coming Again Today.

One phone call. A certified ice machine technician at your door the same day. OEM parts, a flat-rate quote, and a 90-day warranty.

(678) 647-9315
Open Mon–Sat 7 AM–8 PM · Sunday 9 AM–5 PM
📞 Call (678) 647-9315 — Same-Day Service